Means This

The surface must lie between two parallel planes 0.4 apart which are Inclined at 30" to datum plane A. The surface must be within the specified limits of size. See figure 2-14.

FIG. 6-27 SPECIFYING ANGULARITY FOR A PLANE FIG. 6-28 SPECIFYING ANGULARITY FOR AN AXIS

SURFACE <FEATURE RFS)

0.2 wide tolerance zone

Possible orientation of the feature axis

0.2 wide tolerance zone

Possible orientation of the feature axis

Regardless of feature size, the feature axis must lie between two parallel planes 0.2 apart which are Inclined 60* to datum plane A. The feature axis must be within the specified tolerance of locat on.

Note: This control applies only to the view on which It is specified.

Was this article helpful?

0 0

Post a comment