Info

s

!t>

0.2 wide tolerance zone

Datum axis A

Possible orientation of the feature axis

Regardless of feature aize, the feature axis must lie between two parallel planes 0.2 apart which are perpendicular to datum axis A. The feature axis must be within the specified tolerance of location.

Note: This applies only to the view on which it is specified.

FIG. 6-37 SPECIFYING PERPENDICULARITY FOR AN AXIS (BOTH FEATURE AND DATUM FEATURE RFS)

FIG. 6-36 SPECIFYING PERPENDICULARITY FOR A CENTER PLANE (FEATURE RFS)

Was this article helpful?

0 0

Post a comment