Gpj

D-Shaped Feature 5.10.1

Datum

Datum Feature Simulator 1.3.5, A6

Datum Target 1.3.7

Simulated 1.3.5-1.3.6, 4.2.1-4.2.2, 4.4.1-4.4.2, 4.5.1,

Datum Axis 6.7.1, A6

Datum Reference Frame 4.2.2, A6

Datum Referencing Cylindrical Datum Features 4.4.2

Datum Axis and Two Planes 4.4.2

Datum Feature Controls 4.3.3

Datum Feature Identification 4.3.2

Datum Reference Frame 4.2.2, A6

Datum Target Dimensions 4.6.2

Establishing Datums Datum Features Not Subject to Size Variations— 4.5.1

Datum Features Subject to Size Variations 4.5.2

Partial Surfaces as Datum Features 4.5.10

Specifying Datum Features at LMC 4.5.5

Specifying Datum Features at MMC 4.5.4

Specifying Datum Features RFS 4.5.3

Functional Datum Features 4.5.11

Multiple Datum Features 4.5.7

Pattern of Features 4.5.8

Simulation of a Single Darum Plane ... 4.5.7

Single Axis of Two Coaxial Features 4.5.7

Multiple Datum Reference Frames . 4.5.11

Orientation of Two Planes 4.4.2

Parts With Inclined Datum Features 4.4.1

Positioning Parts With Plane Surface Datum

Features 4.4.1

Rotational Orientation 4.4.3

Simultaneous Requirements 4.5.12

Temporary and Permanent Datum Features 4.3.1

Datum Targets

Circular and Cylindrical Targets 4.6.4

Datum Planes Established by Damm Targets 4.6.3

Datum Target Areas 4.6.1

Datum Target Lines 4.6.1

Datum Target Points 4.6.1

Datum Target Symbols 4.6.1

Equalizing Datums 4.6.6

Primary Datum Axis 4.6.4

Secondary Datum Axis 4.6.5

Stepped Surfaces 4.6.3

Definitions 1.3

Dimension

Basic 1.3.9

Dimensioning

Decimal Inch Dimensioning 1.6.2

Dimensioning (Cont'd)

Decimal Points 1.6.3

Dimension Lines 1.7.1, 1.9.2

Dimensioning Features

Chamfers 1.8.15, 2.5

Chords, Arcs, and Angles 1.8.3

Counterbored Holes 1.8.11, 5.7

Counterdrilled Holes 1.8.12, A3

Countersunk Holes 1.8.12

Diameters. 1.8.1, 2.13, 4.3.1, 4.5.2-4.5.3, 4.5.7,

Grid System 1.8.7

Irregular Outlines 1.8.7

Keyseats 1 8.16

Knurling 1.2, 1.8.17

Machining Centers 1.8.14

Outlines Consisting of Arcs 1.8.6

Was this article helpful?

0 0

Post a comment