Control The Median Points Of Opposed Or Correspondinglylocated Elements Of Features

Symmetry is that condition where the median points of all opposed or correspondingly-located elements of two or more feature surface.«; are congruent with the axis or center plane of a datum feature. Where design requirements dictate a need for the use of a symmetry tolerance and symbol, the method shown in Fig. 5-61 may be followed. The explanation given in para. 5.12 applies to the considered feature^), since symmetry and concentricity controls are the same concept, except as applied to different part configurations. Symmetry tolerance and the datum reference can only apply on an RFS basis.

Was this article helpful?

0 0

Post a comment